Cover & Contents Vol.14 No.3

Full Text:

Related Articles

• Performance of light weight ferrocement composite walls
  Yousry Bauomy I. Shaheen, Zeinab Abd El khaleq Etman, Doha Elmetwally Abdelmonem Kandil
  Challenge Journal of Concrete Research Letters (2023) 14(3) 69-88
  The aim of this research is to examine the performance of reinforced lightweight ferrocement walls under vertical and horizontal loading. The walls were made up of two thin layers of ferrocement reinforced with one, two, three, or four layers of welded wire me...
• Mechanical, durability and solar reflectance properties of colored self‒compacting concrete
  Sadık Alper Yıldızel
  Challenge Journal of Concrete Research Letters (2023) 14(3) 89-95
  Urbanized areas are known to have significantly higher temperatures than rural areas. The Urban Heat Island (UHI) effect is caused by surfaces such as asphalt, buildings, and other heat-absorbing surfaces that store more heat than natural vegetation. Sunlight ...
• Experimental study on the mechanical performance of polypropylene fiber-reinforced concrete incorporating palm oil fuel ash as partial cement replacement
  Alaa Omar Tanash, Ahmed Mokhtar Albshir Budiea, Mohd Faizal Md Jaafar, Khairunisa Muthusamy, Fahrizal Zulkarnain
  Challenge Journal of Concrete Research Letters (2025) 16(3) 115-124
  Environmental pollution caused by the disposal of palm oil fuel ash, a type of waste from the palm oil trade, needs to be resolved. At the same time, activities involved in the manufacturing of cement, which is the primary binder in commonly used concrete, hav...
• Tea waste ash: Characterization, pozzolanic activity and effects on the fresh properties of cement pastes
  İlknur Bekem Kara, Cuma Kara
  Challenge Journal of Concrete Research Letters (2025) 16(2) 51-59
  It is a well-known fact that the use of agricultural wastes in cementitious composites by turning them into ash provides both ecological and economic benefits. Tea factories in Türkiye are located in the Eastern Black Sea region. Tea waste generated in factori...
• Nonlinear in-plane response of 3D-printed concrete walls with varied infill patterns: Experimental mix design and numerical structural assessment
  İsmail Hakkı Tarhan, Yeşim Tarhan
  Challenge Journal of Structural Mechanics (2025) 11(3) 160-173
  This study investigates the nonlinear in-plane structural behavior of 3D-printed concrete wall elements with two representative internal infill patterns ‒ lattice (L) and triangular (T) ‒ using finite element modeling informed by experimentally derived materia...