Research Articles | Challenge Journal of Structural Mechanics

Optimal strain gage location for determination of mode I stress intensity factor for orthotropic laminates using a single strain gage

Debabrata Chakraborty, Debaleena Chakraborty, K. S. R. Krishna Murthy


DOI: https://doi.org/10.20528/cjsmec.2016.09.024

Abstract


The present work discusses a robust method developed for determination of mode I stress intensity factor (KI) of orthotropic laminates using a single strain gage and based on a three parameter strain series representation ahead of the crack tip. Appropriate radial location of the strain gage ahead of the crack tip is important in the sense that strain gages placed either very near or very far from the crack tip might lead to inaccuracies in the estimated SIFs due to 3D effects near the crack tip or inaccurate strain field representation at farther distances. The theoretical formulation has been presented for determination of angular location, orientation and the upper bound on the radial location (rmax) for pasting the strain gage which could be subsequently used for accurate determination of KI. Numerical simulations have been presented considering edge cracked [902/0]10S carbon-epoxy orthotropic laminates to illustrate the determination of rmax and KI of such laminates.


Keywords


orthotropic; stress intensity factor; strain gage; gage location; radial location

Full Text:

PDF

References


Chakraborty Debaleena, Murthy KSRK, Chakraborty D (2014). A new single strain gage technique for determination of mode I stress intensity factor in orthotropic composite materials. Engineering Fracture Mechanics, 124-125, 142-54.

http://dx.doi.org/10.1016/j.engfracmech.2014.04.011

Dally JW, Sanford RJ (1987). Strain gage methods for measuring the opening mode stress intensity factor. Experimental Mechanics, 27, 381-388.

http://dx.doi.org/10.1007/BF02330311

Irwin GR (1962). Analytical aspects of crack stress field problems. T&AM Report No. 213, University of Illinois, Urbana.

Sarangi H, Murthy KSRK, Chakraborty D (2010). Radial locations of strain gages for accurate measurement of mode I stress intensity factor. Materials and Design, 31, 2840–2850.

http://dx.doi.org/10.1016/j.matdes.2009.12.043

Shukla A, Agarwal BD, Bhusan B (1989). Determination of stress intensity factor in orthotropic composite materials using strain gages. Engineering Fracture Mechanics, 32, 469-77.6.

http://dx.doi.org/10.1016/0013-7944(89)90318-4

Tada H, Paris PC, Irwin GR (2000). The stress analysis of cracks handbook. ASME, New York.

http://dx.doi.org/10.1115/1.801535

Wu EM (1963). On the application of fracture mechanics to orthotropic plates. T&AM Report No. 248, University of Illinois, Urbana.

---

Peer-review under responsibility of the organizing committee of ICEM17.


Refbacks

  • There are currently no refbacks.